xPico
®
200 Certification Firmware Instructions
15
Bluetooth Continuous Mode Testing
The steps in
http://www.cypress.com/file/298091/download
describe how to run the Lantronix
xPico 200 Bluetooth continuous mode scripts. These scripts are based on the Cypress
mybluetool
commands for the Cypress processor inside of the xPico 200 module.
Running the BT Test Modes
To run the BT Test Modes, follow these steps:
1. Follow the instructions for each type of test in the Cypress document at
http://www.cypress.com/file/298091/download
2. Load the continuous mode firmware as described in the Continuous Mode Software Load
section.
3. Once the firmware is loaded, run the
bt_hci_reset
command twice. The second time this
command is run, it should respond with SUCCESS.
4. After the reset command run the
bt_download_firwmare
command.
5. Table 1 lists the remaining BT commands and syntax. The equivalent commands from
the Cypress document are included.
Note: There are slight differences between the Cypress document command and the
Lantronix command.
