Lantronix SLC8, Руководство пользователя для менеджера, Страница: 159 / 299

12: User Authentication
SLC™ Console Manager User Guide 159
Note: Older RADIUS servers may use 1645 as the default port. Check your RADIUS
server configuration.
Server #1 Secret Text that serves as a shared secret between a RADIUS client and the server (SLC
device). The shared secret is used to encrypt a password sent between the client
and the server. May have up to 128 characters.
RADIUS Server #2 IP address or host name of the secondary RADIUS server. This server can be
used as a SecurID proxy.
Server #2 Port Number of the TCP port on the RADIUS server used for the RADIUS service. If
you do not specify an optional port, the SLC console manager uses the default
RADIUS port (
1812 ).
Server #2 Secret Text that serves as a shared secret between a RADIUS client and the server (SLC
device). The shared secret is used to encrypt a password sent between the client
and the server. May have up to 128 characters.
Timeout The number of seconds (1-30) after which the connection attempt times out. The
default is
30 seconds.
Custom Menu If custom menus have been created (see Local/Remote Users Commands on
page 148 ), you can assign a default custom menu to RADIUS users.
Escape Sequence A single character or a two-character sequence that causes the SLC console
manager to leave direct (interactive) mode. (To leave listen mode, press any key.)
A suggested value is Esc+A (escape key, then uppercase “A” performed quickly
but not simultaneously). You would specify this value as \x1bA , which is
hexadecimal (\x) character 27 ( 1B ) followed by an A .
This setting allows the user to terminate the
connect direct
command on the
command line interface when the endpoint of the command is
deviceport
,
tcp
,
or
udp
.
Break Sequence A series of 1-10 characters users can enter on the command line interface to send
a break signal to the external device. A suggested value is
Esc+B (escape key,
then uppercase “B” performed quickly but not simultaneously). You would specify
this value as
\x1bB , which is hexadecimal (\x) character 27 ( 1B ) followed by a B .
Enable for Dial-
back Select to grant a user dial-back access. Users with dial-back access can dial into
the SLC device and enter their login and password. Once the SLC console
manager authenticates them, the modem hangs up and dials them back. Disabled
by default.
Dial-back Number The phone number the modem dials back on depends on this setting for the
device port. The user is either dialed back on a fixed number, or on a number that
is associated with the user’s login (specified here).
Data Ports The ports users are able to monitor and interact with using the
connect direct
command. U and L denote the PC Card upper and lower slots. U1 denotes the
USB port.
Listen Port The ports users are able to monitor using the
connect listen
command.
Clear Port Buffers The ports whose port buffer users may clear using the
set log clear
command.