Lantronix SLC16, Руководство пользователя

Страница: 338 / 351

Appendix H: DC Connector Instructions
SLC™ Console Manager User Guide 338
3. Using a small screwdriver, press the slot to release the spring pressure for each conductor (as
shown in
Figure H-2 ) and insert the wire. When the wire is in position, release the pressure on
the screwdriver to securely capture the wire.
4. After the leads are installed as shown in Figure H-2 , assemble the strain relief (2 gray pieces)
to the connector plug and snap the connector together as shown in Figure H-3 .
Figure H-3 Plug Parts to Assemble
Caution: Verify wiring before connecting to the SLC console manager. If the
polarity is reversed, you can damage the SLC internal power supply.
5. Connect a Digital Volt/OHM (DVOM) meter to the power source leads and verify the (-48 VDC)
power source.
a. Insert the RED (+) lead of the DVOM into the top hole of the connector for the source
power lead.
b. Then insert the BLACK (–) lead of the DVOM into the bottom hole of the connector for the
return power lead as shown in Figure H-4 .
Figure H-4 Verification of the Power Source
c. Turn on your power source, the voltage should read (-48.00 VDC ±.5 VDC) as shown in
the DVOM in
Figure H-4 .
6. With power source off and SLC power switch off, perform the following steps:
a. Connect the DC power cords to your SLC console server as shown in Figure H-5 .