Lantronix
SDSTX3110-124-LRT-B User Guide
33686 Rev. C
52
4.3.2.2 Port Profile
This page lets you configure serial port parameters.
Label
Description
Port
Port number dropdown to select Port 1 or Port 1 - Port 4, depending on your
Model (SDSTX3110-124-LRT-B shown above).
Local TCP Port
The TCP port the device uses to listen to connections, and that other devices
must use to contact the device. To avoid conflicts with well known TCP ports,
the default is set to
4006
.
Mode
The existing mode (e.g.,
Serial to Ethernet
or
Ethernet
to Serial
- read only).
Flush Data Buffer After
The received data will be queuing in the buffer until all the delimiters are
matched. When the buffer is full (4K Bytes) or after "flush S2E data buffer"
timeout the data will also be sent. You can set the time from 0 to 65535
milliseconds (ms).
Delimiter(Hex 00~ff)
For advanced data packing options, you can specify delimiters for Serial to
Ethernet and / or Ethernet to Serial communications. You can define up to
four delimiters (00~FF, Hex) for each way. The data will be hold until the
delimiters are received or the option Flush Serial to Ethernet data buffer times
out.
0
means disable. Factory default is
0
.
Click the
Apply
button when done to apply the changes.
