Lantronix
C2110 Install Guide
33415 Rev. C
Page 11 of 24
Install the C2110 in the ION Chassis
CAUTION
: Wear a grounding device and observe electrostatic discharge precautions when installing the
C2110. Failure to observe this caution could result in damage or failure of the C2110.
1. Carefully slide the C2110 into an open ION chassis slot, aligning it with the slot guides.
2. Ensure that the C2110 is firmly seated into the slot.
3. Push in and rotate the attached panel Fastener clockwise to secure the C2110 to the ION chassis.
Connect the Fiber Cable
1. Locate a 100Base-FX compliant fiber cable with a male, two-stranded TX to RX connector
installed at each end.
2. Connect the fiber cables to the C2110 as described below:
•
Connect the male TX cable connector to the female TX port.
•
Connect the male RX cable connector to the female RX port.
3. Connect the fiber cables to the other device (another C2110, hub, etc.) as described below:
•
Connect the male TX cable connector to the female RX port.
•
Connect the male RX cable connector to the female TX port.
