Lang ECOF-C-CN, Инструкции по установке, эксплуатации и обслуживанию

Страница: 9 / 31

UL FILE # E8138 9
Installation cont’d
Leg Pad Adapter
Identify the front and rear leg adapters (the front adapters have two threaded
inserts and the rear has four).
Leg to Adapter Installation:
Install the leg’s threaded stud through the hole in the adapter labeled “ C ” with the
bent flange of the adapter facing away from the leg.
Screw the 3/4-inch nut supplied in the adapter kit onto the leg stud and tighten.
Caster to Adapter Installation:
Place the swivel caster against the front leg adapter with the flange of the
adapter facing away from the caster.
Install the four 5/16 inch bolts through the caster base and the adapter holes
labeled “
A ” then install the 5/16 inch nuts with washer and lock washers.
Place the rigid casters against the rear leg adapter with the flange of the adapter
facing away from the caster.
Align the caster to the holes in the adapter labeled “
B ”. NOTE: There are two
sets of “ B ” holes set at 90
°
from the each other. One set will create a left rear
adapter and the other set will create a right rear adapter.
Install four 5/16-inch bolts through the caster base and the adapter holes labeled
“
B ” then install 5/16-inch nuts with lock washers and flat washers.
Adapter to Oven Installation:
Gently tip the oven onto its back. Place the front leg adapter into the front corers
of the oven. The holes without the threaded inserts face the front of the oven
and the flange on the adapter points toward the bottom of the oven.
The edge of the leg adapter with the threaded insert slips under the flange on the
oven side, while the edge without the inserts sits on top of the threaded angle on
the oven front.
Install two 3/8-inch bolts with lock washers and flat washers through the front
holes “
D ” in the leg adapter and into the threaded inserts on the oven.
Thread one 3/8-inch bolt with lock washer and flat washer into the rear threaded
hole labeled “
E ” on each of the leg adapters.
The forward threaded hole on the front leg adapter does not get a bolt installed.
Place the rear leg adapters into the rear corners of the oven so that the adapter
is under the flange of the oven side and back.
NOTE: If installing a caster place the adapter on the oven so that the
casters roll forward.
Install for 3/8-inch bolts with lock washers and flat washers through the holes
labeled “
E ” in the flange of the oven and into the threaded inserts of the leg
adapter.