7
Equipment Description
Exterior Construction
•
The griddle dimensions are 17” (43.18cm) High, 30” (76.20cm) Deep, and width is
dependent on the actual model number.
•
The sidewall is constructed of double wall stainless steel, which allows closer
installation to combustible surfaces.
•
The griddle surface is made of 1¼” thick, highly polished steel to reduce hot and
cold spots, recovery problems, warping, and ensure even heat to the edges of the
griddle.
Operation
•
Temperature control is maintained with a single controller and one RTD probe per
12” section
•
The control has factory configurable maximum and minimum temperature
settings. The maximum temperature value can be set between 400ºF (200ºC) and
550ºF (288 ºC) in 5º increments. The minimum temperature value can be set
between 100ºF and 175ºF in 5º increments.
•
The controls reaction to changes in temperature is also factory configurable with a
hysteresis range of 0ºF (-18ºC) to 10ºF (-12ºC).
•
The controller can be calibrated to griddle surface measurements.
Technical
•
The griddle will operate on either natural gas or propane and can be easily
converted in the field
.
Please reference the conversion instructions listed in this
manual.
•
It is shipped with a power cord and plug attached.
•
Floor space required is 30” (76.20cm) deep, and width is 2ft, 3ft, 4ft, 5ft, or 6ft
depending on actual model number.
Griddle Gas and Voltage Specifications
•
This model can be connected to any 120 Volt source. The gas and electrical
specifications are listed in the table on the following page.
