Landoll Brillion Turfmaker II Series, Руководство оператора

Страница: 104 / 114

5-10 9K998-2306
TABLE OF CONTENTS
Warning Lamps
When plugging in the 7-Pin Warning Lamp Connector:
1. Make sure the Tractor has a good clean Receptacle,
free of dirt and corrosion.
2. Make sure the 7-Pin Connector is inserted ALL the
way in. With tighter fitting pins, operator may think the
Connector is all the way in, but it really isn’t.
3. Make sure the Tractor Receptacle Cover latches over
the keyway on the 7-Pin Connector to hold the
Connector in place.
If an operator plugs in the 7-Pin Connector, but the lights
do not seem to work right, check the above items to make
sure there is a good connection with the 7-Pin Connector.
Figure 5-14: Warning Lamps
Scraper Adjustment
1. Check the Front Roller Assembly Wheels that they
are tight to one another. See “Front and Rear Roller
Adjustment” on Page 5-5.
2. Lower the implement onto level ground.
3. Verify that the Scrapers are centered as best as
possible between the Roller Wheels and adjust if
necessary.
See Figure 5-15.
Figure 5-15: Scraper Alignment
4. Adjust the Scrapers as needed to achieve a 3/16" to
1/4" gap between the Scrapers and Roller Wheels.
See Figure 5-16. Scrapers should be close enough
to the Roller Wheels to be functional but without
interference.
Figure 5-16: Scraper Dimensions
Amber
Lamp
Warning
Lamp Harness
Flasher Control
Module
7-Pin/4-Pin
Harness
Red Lamp
Amber
Lamp
Roller Wheel
Scraper
1/4"
3/16"
Gap
Scraper
Roller Wheel
Scraper
Bracket
Bracket with
4-Hole Plate
Seeder Frame