Landoll 2512 Series, Руководство оператора

Страница: 28 / 42

3-10 F-1040-0320
ASSEMBLY INSTRUCTIONS
TABLE OF CONTENTS
Electrical Installation
1. Attach left and right light brackets with reflectors to
frame using warning light bar, 1/2-13 x 7-1/2 hex
head cap screws, and hex lock nuts
( See
Figures 3-8 thru 3-9 .)
2. Attach ag amber single LED lamps to light brackets
using 1/4-20 x 1-1/4 hex head cap screws and hex
lock nuts.
3. Attach left tail light mount to frame assembly using
u-bolt and 5/8-11 flange head serrated nuts.
4. Attach right tail light mount and ag flasher control
module to frame assembly using u-bolt and 5/8-11
flange head serrated nuts. Be sure that the control
module is set so that the 4 pin connector faces the
right side of the machine.
5. Attach reflector assemblies and ag red single LED
lamps to tail light mounts using 1/4-20 x 1-1/2 hex
head cap screws and hex lock nuts.
IMPORTANT
Make sure lights are positioned for maximum
visibility from the rear.
1.
Install the LED warning light harness to the frame.
Connect 2 pin and 3 pin ends to each of the warning
lights. Connect 6 pin to the ag flasher control module.
2. Attach 7 pin/4pin 120” harness to frame. Connect 4
pin end to the ag flasher control module.
3. Ensure that the harnesses are clear of any moving
parts and secure the harnesses with tie wraps
provided.
4. Install the stor-away holder bracket on bolt in coulter
clamp plate and assemble harness stor-away to
bracket with 1/4-20 x 3/4 hex head cap screws and
hex lock nuts.
General Hydraulic Components -
Hydraulic Reset Option
Figure 3-10 is provided as a general guideline for the
components provided with the Hydraulic Reset Option. It
is meant to assist with identifying components on the
machine. Each machine size will use a specific quantity
of each component during assembly. Please refer to
F-1039 Parts Manual for proper quantity per tool.