Landmann avalon PTS 5.1 Plus, Сборка и руководство по эксплуатации

Страница: 9 / 36

9
avalon PTS 5.1+
2. Make sure that the seal in the pressure regulator
(G4) is present and intact. Do not use any additi-
onal seals.
3. Connect the coupling nut (G3) of the pressure
regulator to the cylinder valve thread (G2) and
tighten the coupling nut (G3) by turning it anti-
clockwise by hand.
4. Do not use any tools for this, as the cylinder valve
seal could be damaged in the process, resulting in
leaks.
5. Check the connection between pressure regula-
tor connection (G5) – gas hose (G7) is secured cor-
rectly. For this purpose, securely tighten the hose
clamp (G6) using a screwdriver.
6. Stow the gas cylinder (G1) in the storage space on
the gas cylinder shelf (23) underneath the barbe-
cue. Proceed as follow:
7. Fold up the gas cylinder retaining bar (22) on the
right side wall.
– Set the gas cylinder (G1) upright in the recess
in the base.
– Place the gas cylinder retainer bar (22) over the
gas cylinder (G1) to secure the cylinder against
falling over.
16
15
G0
Gas cylinder connector
Do not store spare gas cylinders in the storage
area below the barbecue! The floor of the trolley
is not designed for this.
8. Make sure that there are no sources of ignition
within a 5 m radius. Important note: to avoid the
risk of spark-over, do not to light naked flames,
do not smoke and do not actuate the switches of
electric devices (appliances, lights, door bells, etc.).
9. Open the cylinder valve (turn G2 anti-clockwise)
and use a standard leak detector to make sure
that all of the gas connections are tight.
– Please follow the instructions for the leak indi-
cator! Never check for leaks using a naked fla-
me. Listening for leaks is not a reliable method
of detection.
– If a leak is detected, close the cylinder valve
immediately (turn G2 clockwise) and tighten
the loose connection or replace the leaking
part. Repeat the leak test.
10. If you do not wish to barbecue immediately, close
the cylinder valve (turn G2 clockwise).
Connecting the gas cylinder
1. Open the doors and route the pressure regulator
(G4) through the hole in the right side wall into
the inside of the trolley.
When performing the next steps, make sure that
the gas hose is not kinked or under tension.
Connecting and disconnecting
the gas cylinder
Parts and tools needed
• Gas cylinder
CommonPatio Gas cylinder, fill weight 5 or 13
kg, (e.g. green Propane Gas cylinder). These are
available at DIY shops or from liquid gas suppliers.
Leak indicator
• You can locate any leaks in the gas system using a
leak detector. This can be purchased at DIY shops
or liquid gas suppliers. Please follow the operating
instructions of the leak detector.
The following parts are included in delivery. They
comply with the standards applicable in the country
to which they have been supplied by Landmann.
Gas hose (pre-assembled)
-approved hose of a sufficient length (max. 1.5
m) to allow for kink-free assembly.
• Pressure regulator (already attached to the gas
hose)
Preset and -approved pressure regulator, max.
1.5 kg/h, operating pressure 28-30/37 mbar, suita-
ble for the gas cylinder used.
Permitted gas cylinder sizes
5 kg: Ø 300mm x 390 mm
13 kg:
Ø 315mm x 580mm
(Will not fit in cabinet)
It is recommended that you only use Calor Patio Gas
with your LANDMANN barbecue which is fitted with
a 27mm Clip on gas regulator!