3
Assembly Instructions
• Connect the Accessories Harness
from the inside of the POD to
the back of the upper board.
• Feed the Upper harness connection
on the edge of the upper board,
down the side access hole in the
POD and down the upright leg.
• Carefully pitch the display mem-
brane into operational position,
but DO NOT PRESS ALL THE
WAY IN.
• Proceed with assembly until you
can verify connections are correct
– THEN PRESS INTO POSTION.
• Feed upper harness down the leg
connecting to blue harness clips.
• BE SURE TO LEAVE SLACK
UPTOP SO YOU CAN STILL
PITCH THE PANEL BACK
UNHINDERED BY HARNESS
LENGTH
• Feed harness though access hole
at the bottom and complete
connections to components
• Carefully align the upright cover
to upright. Align one edge and
slide all the way up and under
the POD concealing the top edge.
• Once the cover is in position,
press the other edge until the
cover snaps in.
STEP 12:
Connect accessory harness
STEP 13:
Position the membrane
STEP 14:
Route the wire harness
STEP 16:
Install upright covers
• Check the tension on the
drive belt by placing the drive
belt between your thumb and
forefinger and twisting.
• The proper twist is 45˚. If the
belt needs to be adjusted use a
7/16” socket and turn the bolt
underneath the motor pan
attached to the motor’s
hook screw.
STEP 17:
Check drive belt tension
• The treadbelt is tracked and
tensioned via the take-up
screws located at the back of
the treadmill.
• Check the tension of the
treadbelt. At proper tension you
should be able to place your
hand between the belt and deck
and reach the center of the
treadmill. If you cannot reach
the center, the belt is too tight
and must be loosened. If your
hand reaches past the center the
belt is too loose and must be
tightened.
STEP 18:
Adjust the treadbelt
• Remove the black motor cover
screws in the side of the frame.
Place motor cover onto
treadmill.
• Attach motor cover with Phillips
head screws provided. Place
rubber spacer between cover
and frame.
• Plug treadmill into a dedicated
15A outlet. Walk on treadmill at
approximately 2.5 mph for 20 to
45 minutes to properly walk in
lubricant.
STEP 19:
Install motor cover
HOME/LTD TREADMILL:
• Route the wire harness underneath
the elevation motor and secure with
harness restraint clip provided. Plug
connector into circuit board until
it snaps.
CONNECT INSULATED
GROUND LEAD FROM HARNESS
TO AVAILABLE PAN GROUND LEAD.
COMMERCIAL TREADMILL:
• Route the wire harness behind
the elevation motor and secure
with harness restraint clip provided.
Plug connector into circuit board until
it snaps. CONNECT INSULATED
GROUND LEAD FROM HARNESS
TO AVAILABLE PAN GROUND
LEAD.
STEP 15
Motor pan connection
