DATA SETTING
Programmer tester Mod. V05
13
fig. 38
MEMORY
DELETION
MINIMUM RPM
FOR CUTOFF
1500 RPM
fig. 34
POSITION ON
CUTOFF
80 STEPS
fig. 35
FIXED DEFAULT
OPTION
NOT ENABLED
fig. 36
FIXED DEFAULT
POSITION VALUE
100 STEPS
fig. 37
MINIMUM RPM FOR CUTOFF
Engine speed at which the cut-off function ends and the central unit repositions the linear actuator with stepper
motor at the default position (fig. 34).
By enabling this function the value of 1500 rpm is suitable for most vehicles.
POSITION ON CUTOFF
This is the position at which the linear actuator with stepper motor positions itself during the cut-off phase. This
value is generally 30 steps less than the default position (fig. 35).
FIXED DEFAULT OPTION
This option keeps the carburation control strategies of a normal default. However, it can be used in emergencies
such as if the lambda sensor has broken or is functioning badly (fig. 36).
In some cases it can be used to force a default more open or more closed consequently making the mixture richer
or leaner.
Caution: This option does not have the function of a fixed register.
FIXED DEFAULT POSITION VALUE
This is the default value set on the basis of the requirements established in the
FIXED DEFAULT OPTION
(fig. 37). Anyhow, it is the position the linear actuator with stepper motor will take in the conditions of the lambda
sensor being cold or out of order.
MEMORY DELETION
On this “page” the control unit reset procedure is actuated, thereby restoring the factory settings and taking the
default position of the linear actuator with stepper motor back onto 100 steps (fig. 38).
Therefore, in the case of resetting, re-enter the parameters that may have been changed and which
correspond to the vehicle.
