Section 1: Assembly & Set-up
11/2/18
RCP2660, RCPM2660, RCP3060 & RCPM3060: Parallel Arm Rotary Cutter: 316-111M:
17
Driveline Maximum Extended Length
Figure 1-6
Check Driveline Maximum Length
The driveline maximum allowable length must, when fully
extended, have a minimum overlap of profile tubes by not
less than 1/2 the free length with both inner and outer
profile tubes being of equal length.
1.
Apply multi-purpose grease to the inside of the outer
shaft and reassemble the driveline.
2. Assemble the two driveline profiles together with just
1/2 overlapping of the profile tubes as shown. Once
assembled, measure and record maximum allowable
length here. ________
Check Driveline Interference
1.
Make certain driveline yokes are properly attached.
See steps 2 -10 on page 16.
2. Start tractor and raise Parallel Arm Rotary Cutter just
enough to remove support blocks from under the
cutter.
3. Slowly engage tractor hydraulic 3-point control lever
to lower cutter while checking for sufficient drawbar
clearance. Move drawbar ahead, aside, or remove if
required.
24804
Outer Shielding has been removed for clarity.
4. With power take-off off, raise implement fully up to
make the following checks below. If driveline exceeds
any of the limits listed, set tractor 3-point lift limiter at
a height that will keep the driveline within its lift limits
and to avoid premature driveline breakdown.
•
Driveline does not exceed 25
o
up.
•
Driveline does not exceed maximum allowable
length recorded in step 2 under
Maximum Driveline Movement During Operation
Figure 1-7
Install Stabilizer Turnbuckles
If installing Kubota stabilizer turnbuckles, first, level the
deck and then install Kubota turnbuckles. Refer to
IMPORTANT:
Lightweight tractors with rear attached
24872
Содержание RCP2660
Страница 72: ......
Страница 73: ......
Страница 74: ...Corporate Office P O Box 5060 Salina Kansas 67402 5060 USA www landpride com ...