Land Pride RCF3096, Руководство оператора

Страница: 30 / 76

Section 1: Assembly & Set-Up
Table of Contents
RCF3096, RCF3010, & RCFM3010 Rotary Cutters 326-566M
26
11/8/18
Check Driveline Minimum Length
Figure 1-18
Check Driveline Collapsible Length
1. With driveline attached only to the cutter, remove
outer driveline (tractor end) from inner driveline to
separate the two profiles.
2. Park tractor and cutter on a level surface.
3. Raise cutter until gearbox input shaft is level with
tractor power take-off shaft. Securely block cutter at
this height to keep unit from lowering.
4. With cutter resting on the support blocks, shutdown
the tractor using “Tractor Shutdown Procedure” on
page 11.
5. Attach outer driveline to the tractor’s power take-off
shaft. Refer to “Driveline Hook-up (Semi-Mount)”
on page 25, steps 5-6.
6. Hold inner and outer drivelines parallel to each other
as shown in Figure 1-18. Measure dimension “A”.
•
If "A" is less than 1", skip to step 9.
•
If “A” is greater than or equal to 1", continue with
step 7 below.
7. Lubricate and reassemble inner and outer driveline
profiles. Refer to
“Lubrication Points” on
pages 63-64.
8. Complete driveline hook-up to the tractor’s power
take-off shaft. Refer to:
•
“Driveline Hook-up (3-Point)” on page 18
•
“Driveline Hook-up (Semi-Mount)” on page 25.
22311
IMPORTANT: A driveline that is too long can bottom
out causing structural damage to the tractor and
implement. Always check driveline minimum length
during initial setup, when connecting to a different
tractor, and when alternating between using a quick
hitch and a standard 3-point hitch. More than one
driveline may be required to fit all applications.
Shorten Driveline Length
Figure 1-19
9. If dimension “A” is less than 1", shorten driveline as
follows:
Refer to Figure 1-19:
a. Measure 1" ( “B1” dimension) back from outer
driveline shield and make a mark at this location
on the inner driveline shield.
b. Measure 1" ( “B2” dimension) back from the inner
driveline shield and make a mark at this location
on the outer driveline shield.
10. Remove outer driveline from the tractor power take-
off shaft and inner driveline from the cutter gearbox
shaft.
11. Cut off non-yoke end of inner driveline as follows:
a. Measure from end of inner shield to scribed mark
( “X” dimension) and record.
b. Cut off inner shield at the mark. Cut same amount
off the inner shaft ( “X1” dimension).
12. Cut off non-yoke end of outer driveline as follows:
a. Measure from end of outer shield to scribed mark
( “Y” dimension) and record.
b. Cut off outer shield at the mark. Cut same amount
off the outer shaft ( “Y1” dimension).
13. Remove all burrs and cuttings.
14. Lubricate and reassemble inner and outer driveline
profiles. Refer to “Lubrication Points” on
pages 63-64.
15. Complete driveline hook-up to the tractor’s power
take-off shaft. Refer to:
•
“Driveline Hook-up (3-Point)” on page 18
•
“Driveline Hook-up (Semi-Mount)” on page 25.
22311