10
Section 1: Assembly and Set-Up
RCR3596, RCRM3596, RCR3510 & RCRM3510 Rotary Cutters 312-517M
8/15/12
Table of Contents
Torque Requirements
Refer to “Torque Values Chart” on page 41 to
determine correct torque values for common bolts. See
"Additional Torque Values" at bottom of chart for
exceptions to standard torque values.
Gearbox Vent Plugs & Dipsticks
Vent Plug Installation
Refer to Figure 1-2:
A vent plug is shipped loose and packaged with the
Operator’s Manual. Remove temporary solid plug on top
of T-box and replace with included 3/8" vent plug. See
your nearest Land Pride Dealer if vent plug is missing.
Figure 1-2
Vented Dipstick Installation
Refer to Figure 1-3:
Vented dipsticks are shipped loose and packaged with
the Operator’s Manual. See your nearest Land Pride
Dealer if dipstick is missing. Remove temporary pipe
plug from top of each gearbox and replace with supplied
dipsticks.
Figure 1-3
IMPORTANT: Rotary Cutters are shipped with a
solid plug in the gearbox to prevent loss of oil during
shipping and handling. The solid plug on top of the
gearbox must be replaced with a vented dipstick. Do
not operate cutter without vented dipstick installed.
22320
Remove 3/8" T-Box Solid
Plug & Install Vent Plug
DO NOT
OVERFILL!
30216
DO NOT
OVERFILL!
Oil Level
Plug
Remove
Pipe Plug
Install
Vented Dipstick
