Lancia Ypsilon, Руководство пользователя

Страница: 78 / 222

77
SAFETY
DEVICES
CORRECT
USE OF
THE CAR
WARNING
LIGHTS AND
MESSAGES
IN AN
EMERGENCY
CAR
MAINTENANCE
TECHNICAL
SPECIFICATIONS
INDEX
DASHBOARD
AND CONTROLS
BONNET
TO OPEN THE BONNET
Proceed as follows:
❒
pull lever A-fig. 81 in the direction
of the arrow;
❒
move lever B-fig. 82 leftwards as
shown by the arrow;
❒
lift the bonnet and at the same time
release the rod C-fig. 83 from the
catch D-fig. 83 , then fit the rod end
into the bonnet recess E-fig. 83
(wide hole) and then press down to
safety position (small hole), as shown
in the figure.
IMPORTANT Before opening the bon-
net, check the windscreen wiper arms
are not lifted from the windscreen.
fig. 81 L0C0021m fig. 83 L0C0220m
TO CLOSE THE BONNET
Proceed as follows:
❒
hold the bonnet up with one hand
and with the other remove rod C-
fig. 83 from recess D , with reverse
movement with respect to opening,
and fit it back into its catch;
❒
lower the bonnet at approx. 20 cm
from the engine compartment and
then let it drop, ensuring that it is
fully closed and not just held in po-
sition by the safety catch. If the
bonnet does not close properly do
not push it down but open it again
and repeat the above procedure.
IMPORTANT Always check that the
bonnet is closed properly to avoid its
opening while the car is travelling.
fig. 82 L0C0270m
077-090 Ypsilon GB 10-10-2008 10:19 Pagina 77