Lancia Lybra, Руководство пользователя

Страница: 122 / 298

121
When the handbrake lever is pulled
up and the ignition key is at MAR the
panel warning light
x
will come on.
To release the handbrake:
1 ) Slightly lift the handbrake and
press release button A .
2 ) Keep the button pressed in and
lower the lever. Warning light
x
will
go out.
3 ) To prevent accidental movement
of the car, this procedure should be
carried out with the brake pedal
pressed down.
fig. 116
P4T0055
To change gear properly
you must push the clutch
pedal fully down. It is
therefore essential that there is
nothing under the pedals: make
sure mats are lying flat and do not
get in the way of the pedals. Make
sure mats are lying flat and do not
get in the way of the pedals.
MANUAL GEARBOX
To engage the gears, press down the
clutch and put the gear lever into one
of the positions shown in the diagram
in
fig. 117 (the diagram is also on the
gear lever knob).
To engage reverse ( R ): wait for the
car to come to a standstill and from
neutral position shift the lever to the
right and then back.
In some versions, lift ring A ( fig.
117 ) under the knob with the fingers
of the hand operating the lever. Re-
lease the ring after engaging reverse.
You do not need to lift the ring to
shift to another gear from reverse.
P4T0031
Do not drive with your
hand resting on the gear
stick as the force exerted,
even if only slight, could lead to
premature wearing of the gearbox
internal components.
Reverse can only be en-
gaged when the car is at a
standstill. Wait for two
seconds or longer with the clutch
pedal fully pressed before engag-
ing reverse when the engine is
running to prevent scraping and
damaging the gears.
fig. 117