5
5. Ensure the icemaker is installed properly to allow for removal
of the Merchandiser.
6.
Ensure manual fill is accessible.
7. Clean and maintain icemaker per manufacturer’s
instructions.
Dispenser Installation
The installation, and relocation if necessary, must
be carried out by qualified personnel with up-to-date
knowledge and practical experience, in accordance with
current regulations.
NOTE
1. Remove the cup rest, drip tray, splash plate, merchandiser,
and top cover from the unit.
2. Route appropriate tubing from the water source to the plain
water inlet at the front of the unit and connect tubing to inlet
using the oetiker pliers and fittings,(see Plumbing Diagrams
on the front of the unit or on pages 26-27 for reference).
3.
Connect tubing to water source then flush water lines to
check for leaks.
4. Route appropriate tubing from the remote pump deck to the
carbonated water inlet and connect tubing to inlet.
5. Route appropriate tubing from the syrup pump location to the
syrup inlets and connect tubing to all syrup inlets.
6.
For units with a flavor shot module, route appropriate tubing
from the flavor shot pump location to the flavor shot inlets at
the front of the unit and connect tubing to inlets.
7. Route appropriate tubing from the CO
2
source location to the
CO
2
inlet on the unit and connect tubing to inlet.
A
B
C
A. CO
2
Inlet
B. Fitting
C. Tubing
A
B
C
A. Oetiker Pliers
B. Fitting
C. Tubing
D. Syrup/Water Inlet
D
8. Route the power supply cord to a grounded electrical outlet
of the proper voltage and amperage rating.
DO NOT PLUG UNIT INTO GROUNDED ELECTRICAL
OUTLET AT THIS TIME.
Make sure that all water lines
are tight and unit is dry before making any electrical
connections
!
WARNING
Drain line must be insulated with a closed cell
insulation. Insulation must cover the entire length of
the drain hose, including fittings. The drain should be
installed in such a manner that water does not collect
in sags or other low points, as condensation will form.
!
CAUTION
Pouring hot water down the drain may cause the Drain
Tube to collapse. Allow only luke warm or cold water to
enter the Drain Tube.
Pouring coffee, tea, or other
similar substances down the drain may cause the Drain
Tube to become clogged.
!
ATTENTION
A
A. Drain Fitting
B. Drain Line
C. Drip Tray
B
C
9.
Route drain hose from designated open type drain to fitting
on Drip Tray and connect hose to fitting.
10. Reattach Drip Tray/Cup Rest to unit.
Remote Pump Installation
1.
If necessary, install water booster (Lancer PN MC-163172)
between water supply and the unit.
2.
Using tubing cutters, cut water line and install tee fitting, then
route appropriate tubing from the remote pump location to
the tee fitting at water line.
A
B
C
D
A. Tee Fitting
B. Line to Plain Water Inlet
C. Line to Water Source
D. Line to Remote Pump
3.
Connect line from tee fitting at water line to the remote pump
deck inlet regulator.
4. Complete the carbonated water line connection, installed in
the previous section, between the remote pump deck and
carbonated water inlet on the unit.
5.
Install a shut-off valve in the water line feeding the deck. If a
separate water line is run for plain water, ensure that it also
has a shut-off valve.
