lancer 85-3151R-VV, Руководство по эксплуатации

Страница: 21 / 36

21
I. PROGRAM MODE
NOTE:
The unit supports separate portions with up to 1 topoff for each brand
If the unit has an Active Brand, the PROGRAM MODE can be accessed by pressing and holding
both the SM and XL buttons.
• During PROGRAM MODE, the Mode LED blinks.
• During PROGRAM MODE and its sub-modes, all dispenses use the Active Brand.
• During PROGRAM MODE and its sub-modes, the information stored for a Size is ONLY for the
Active Brand
1. Put desired amount of ice in cup, place cup under valve
2. Press and hold the size to be programmed until cup fills to desired portion
3. If a topoff is not recessary, return to Step 1 with a different size or press the Active Brand to exit
portion program mode and save the programmed sizes.
4. Wait for foam to settle, then press and hold the size again to top off.
5. Return to Step 1 with a different size or press the Active Brand to exit portion program mode
• The unit will default to IDLE MODE automatically, if the unit is NOT dispensing AND the last
button press AND last dispense
J. CALIBRATED CUP PORTION CONTROL PROGRAMMING FOR VOLUMETRIC MODE
NOTE: In this mode, the unit adds the volume from each programming step to the total drink size.
When the portion is dispensed from idle mode, the entire drink is dispensed without pauses.
If unit has an Active Brand selected, Calibrated Cup Portion Control Programming MODE can be
accessed by pressing and holding both the SM and LG buttons.
• During Calibrated Cup Portion Control Programming MODE, the Mode LED blinks.
• During Calibrated Cup Portion Control Programming MODE and its sub-modes, all dispenses use
the Active Brand.
• During Calibrated Cup Portion Control Programming MODE and its sub-modes, the information
stored for a Size is ONLY for the Active Brand.
1. Place volume cup under nozzle.
2. Press appropriate size and fill volume cup to a point just short of the calibration mark on the
volume cup. LED will turn ‘on’ while programming an individual cup size
3. Allow foam to settle, jog size button until liquid reaches the calibration mark on the volume cup.
4. Press the Active Brand to end programming the selected cup size. LED will return to blinking.
5. Start at step 1 with a different size or press the Active Brand to exit Program Mode and save
sizes.
• The unit will return to IDLE MODE automatically, if the unit’s last button press AND last dispense
were both at least 60 (sixty) seconds prior, the unit will save the programmed portions.