lancer 28-0586/07, Руководство по эксплуатации

Страница: 28 / 54

7. TROUBLESHOOTING
7.1 REFRIGERATION SYSTEM
F
WARNING
THE COMPRESSOR DECK IS FED BY LINE VOLTAGE. DISCONNECT POWER BEFORE ATTEMPTING
TO REPAIR ANY COMPONENTS ON THE DECK.
ADVERTENCIA
LA CUBIERTA DEL COMPRESOR ES ALIMENTADO POR LA TENSIÓN DE LÍNEA. DESCONECTE
LA ENERGÍA ANTES DE INTENTAR PARA REPARAR TODOS LOS COMPONENTES DE LA CUBIERTA.
AVERTISSEMENT
LE COMPRESSEUR EST ALIMENTÉ EN DIRECT PAR UN VOLTAGE EN LIGNE. DÉBRANCHEZ
L’ÉLECTRICITÉ AVANT LA RÉPARATION D’UN DES COMPOSANTS DU DECK.
The refrigeration system consists of a compressor, condenser, evaporator, fan, and control box.
The components are mounted on a common base or deck. The fan and compressor are electrically
connected in parallel. The ice bank control module, located in the control box, is connected to a
probe that is mounted to the evaporator coils. The probe senses the presence of ice and signals the
controller to turn the compressor/fan off. The probe must be in water for the compressor to run. The
module also has a delay (approximately five minutes) to prevent the motor from starting under load.
This would occur if the power were interrupted, as well as on initial start-up.
The ice bank control module (inside the control box) has a red and a green LED mounted on the
board. The green light indicates that line voltage is being supplied to the module. The red LED will
be on when the controller instructs the compressor to run.
7.2 RESET TO FACTORY DEFAULTS
The “Factory Defaults” item will restore the settings to the defaults. you will be asked to confirm
this action. When you select YES , the dispenser will reset and start up with the defaults. On older
units, if the unit is a 2-Valve unit , you will need to set it back to 2-Valve , as the default setting is
4-Valve .
28