4/8/16 Port USB/PS2 Rack Mountable KVM Switch User Manual
19
Single device installation
Note
: Before installation, make sure that the equipment is powered off. To prevent damage to the
equipment during installation, make sure that all the devices installed are well grounded.
To install a single;level KVM, refer to the following online diagrams (numbered in the order of steps
on the online graph) and operate as per bellowing:
1. Plug your USB keyboard, mouse, or PS/2 keyboard and mouse into the USB or PS/2 console
port on the rear of the switch.
2. Connect the VGA monitor's video signal cable to the VGA console port and turn on the power.
3. Plug the VGA connector into the VGA port of any available VGA port on the switch by using a set
of KVM cables corresponding to the product model.
4. Connect the corresponding VGA video connector, USB or PS/2 connector of the KVM cable to
the corresponding PC port.
5. Plug the power adapter supplied with this package into the AC power supply, and plug the other
end of the power adapter into the power jack on the switch.
6. Connect the network cable to the IP port of the IP module.
7. Turn on the computer.
Note:
1. Make sure all plugs are connected to the same set of KVM port jacks (all on port 1, or all
on port 2).
2. The IP module is an optional module of the product. If the product you purchased does not
contain the module, please ignore the related operation in Step 6.
3. Before using the IP module, please make the corresponding configuration and network
debugging, and then connect to the network you want to connect. Otherwise, the IP module may
not be able to control normally because of the connection failure. (Refer to the manual of the IP
module product manual for how to use and debug the IP module.)
