22
warranty verification. If it should become necessary to return the instrument during or
the warranty period, contact our Technical Service Department at 1-800-344-3100 or
1-410-778-3100, ext. 3 or [email protected] for a return authorization
number or visit www.lamotte.com for troubleshooting help. The sender is responsible
for shipping charges, freight, insurance, and proper packaging to prevent damage in
transit. This warranty does not apply to defects resulting from action of the user such
as misuse, improper wiring, operation outside of specification, improper maintenance
or repair, or unauthorized modification. LaMotte Company specifically disclaims any
implied warranties or merchantability or fitness for a specific purpose and will not be
liable for any direct, indirect, incidental, or consequential damages. LaMotte Company’s
total liability is limited to repair or replacement of the product with a new or refurbished
meter as determined by LaMotte Company. The warranty set forth above is inclusive
and no other warranty, whether written or oral, is expressed or implied.
TROUBLESHOOTING
ERROR MESSAGES
Over Range
If the message OVERRANGE is displayed when scanning a sample, the sample may be
over range or under range. If the sample is over range, the sample should be diluted and
tested again (see Sample Dilution Techniques and Volumetric Measurements).
If overrange is displayed, scroll to
Calibrate
and press
ENTER
to view the result. The
concentration is only an
approximation
.
Press
EXIT
and continue testing.
Note: If
EXIT
is not pressed the meter will
calibrate on the over range result.
Note: Over range results will also be
displayed in the test log.
045 Fluoride
Overrange
<Enter> continue
Scan Blank
Scan Sample
12:00:00 001/500
CALIBRATION
As with all pre-calibrated meters, it is highly recommended, even if not required by
regulations, that the user periodically verify the performance of the meter by running
standards with a predetermined concentration. Results outside of specification are
an indication that the meter needs to be adjusted. This can be done following the user
calibration.
STRAY LIGHT
The colorimeter should have no problems with stray light. Make sure that the sample
compartment lid is always fully closed.
