Exclusive to Howdens Joinery.co
Page _ 14
Electrical Connections
IMPORTANT: Ensure that the electricity supply is switched off before connecting. Your Extractor is
intended for permanent installation.
Your appliance must be connected to
t
e
lt
u
o
r
u
p
s
d
e
s
u
f
d
e
h
c
ti
w
s
e
l
o
p
e
l
b
u
o
d
a
f
o
e
s
u
e
h
t
a
i
v
g
n
ir
i
w
with at least 3mm contact separation. The isolation switch must be accessible after installation. (See
technical data for fuse rating).
We strongly recommend the appliance is connected by a
electrician and the installation must
comply with the I.E.E and any local regulations.
The terminology DOUBLE POLE -/+ means that both the live and neutral supplies are switched and
disconnected at the same time.
The terminations labelled SUPPLY are the connections for the internal house wiring and the terminations
labelled LOAD are for connection to the appliance.
IMPORTANT: The wires in the mains lead are coloured in accordance with the following code:-
Blue..........Neutral
Brown......Live
As the colours of the wires in the mains lead of this appliance may not correspond with the coloured
markings identifying the terminals in your spur box, proceed as follows;
The wire which is coloured blue must be connected to the terminal which is marked with the letter
‘N’ or coloured BLACK. The wire which is coloured brown must be connected to the terminal which is
marked with the letter ‘L’ or coloured RED.
Fig 3.
Fig 4.
N
L
L
N
LOAD
SUPPLY
LOAD
SUPPLY
DP
250V~
FUSE
ON
Blue.
(Neutral)
Brown.
(Live)
Green / Yellow.
(Earth)
User manual LAM2203
