8. Attach the front door panel on the extractor.
9. Attach the vent house for the ducting out.
www.howdens.com
Page _ 13
3.
Prepare mounting brackets, checking that the
retainer screw (F) is fitted.
4.
Mark the wall with a pencil for height above the
55mm
E
F
worktop and fixing bracket hole centres.Fix brackets
to the wall securely.
5.
Cut the plastic trim infill piece (G) to the correct
depth and screw to the extractor body.
Hook the extractor onto the installed brackets.
Adjust alignment of extractor to cabinet edges
using the bracket screws (E)
and (F) and tighten.
6.
Once correctly aligned to the cabinets, securely fix
the extractor to the side cabinets through screw holes
in the side panels of the extractor.
Align template onto the rear face of the frontal.
Mark and pilot drill the 4 holes (
Ø
2mm) marked
on the template.
Screw in (not fully) the upper 2 screws (1).
Place front panel against the door, over the key
holes and push up and secure firmly.
Screw in the lower fixing screws (2) to secure.
•
•
•
•
•
7. Door panel fixing - Draw a vertical centre line on the
rear face of the frontal.
Ø2 x 4
598mm
502mm
38mm
393mm
Worktop
1
Min
094mm
E
G
F
555mm
1
2
