Lamborghini Caloreclima GASTER N 119, Инструкция по эксплуатации

Страница: 20 / 96

GASTER N 119 ÷ 289 AW
20
cod. 3541F272 - Rev. 00 - 06/2018
EN
1. Operating instructions .................................. 21
1.1 Introduction .................................................. 21
1.2 Control panel ............................................... 21
1.3 Lighting and shutdown................................. 21
1.4 Adjustments ................................................. 21
1.5 Maintenance ................................................ 22
1.6 Faults ........................................................... 22
2. Installation ...................................................... 22
2.1 General Instructions .................................... 22
2.2 Place of installation...................................... 22
2.3 Plumbing connections ................................. 23
2.4 Gas connection............................................ 23
2.5 Electrical connections .................................. 24
2.6 Connection to the flue .................................. 25
Certification
The CE marking attests that the LAMBORGHINI gas-fired units comply with the requirements con-
tained in the applicable European directives.
In particular, this unit complies with the following EEC directives:
• Gas Appliance Directive 2009/142 implemented by Pres. Decree no. 661 of 15.11.96
• Efficiency Directive 92/42 implemented by Pres. Decree no. 660 of 15.11.96
• Low Voltage Directive 2006/95
• Electromagnetic Compatibility Directive 2004/108
This symbol indicates "Attention" and is placed next to all safety warnings. Carefully follow these instructions
to prevent any risk of damage or injury to people, animals or property.
This symbol indicates an important note or information
• Read this instruction booklet carefully, as it provides
important information on safe installation, use and
maintenance.
• This instruction booklet is an integral and essential
part of the product and must be kept with care by the
user for future reference.
• If the unit is sold or transferred to another owner or if
it is to be moved, always make sure the booklet stays
with the boiler so that it can be consulted by the new
owner and/or installer.
• Installation and maintenance must be carried out by
professionally qualified personnel, according to the
current regulations and the manufacturer's instructions.
• Incorrect installation or poor maintenance can result
in damage or injury. The manufacturer declines any
responsibility for damage caused by errors in installa-
tion and use or by failure to follow the manufacturer's
instructions
• Before carrying out any cleaning or maintenance opera-
tion, disconnect the unit from the power supply using
the switch and/or the special cut-off devices.
• In case of a fault and/or poor operation, deactivate
the unit and do not try to repair it or directly intervene.
Contact professionally qualified personnel.
• Any repair/replacement of the products must only be
carried out by qualified personnel using genuine parts.
Failure to comply with the above can compromise the
safety of the unit.
• Yearly maintenance carried out by qualified personnel
is essential for guaranteeing good operation of the unit.
• This unit must only be used for its intended purpose. Any
other use is deemed improper and therefore hazardous.
• After unpacking, check the good condition of the
contents.
• The packing materials are potentially hazardous and
must not be left within the reach of children.
• In case of doubt, do not use the unit. Contact the supplier.
3. Service and maintenance .............................. 25
3.1 Adjustments ................................................. 25
3.2 Commissioning ............................................ 26
3.3 Maintenance ................................................ 27
3.4 Troubleshooting ........................................... 30
4. Technical data and characteristics .............. 31
4.1 Dimensions and connections....................... 31
4.2 General view and main components ........... 32
4.3 Technical data table ..................................... 33
4.4 Diagrams ..................................................... 33
4.5 Wiring diagrams........................................... 34