26
washing cycle you chosed will be extended up to
having reached the exact temperature (thermocontrol).
G – Extracting the basket inclines and shakes it
carefully. So the rest of the water drops will be
eliminated.
Leave the dishes in the basket until its will be dry by
evaporation. Take the dishes away from the basket
and pay attention not to touch the dishes on its border
and put the on clean shelves.
To continue carry a new basket, introduce it in the
machine, close the door and press button
“C”.
-
Endless cycle (maximum 15 minutes)
: the door
being closed and the cycle put on (any cycle), keep the
button
“B”
pressed for 3 seconds: lamps 1 and 2 will
flash at the same time (thermocontrol excluded); the
cycle can be interrupted at any time pressing again
button
“C”
that will let final sequences start.
Self-washing cycle:
with machine on, carry out the
following operations:
-
Remove the overflow from the tank and wait
for the tank’s emptying (for machines with
drain pump, look at the instructions in the
specific paragraph),
-
Close the door of the glasswasher,
-
Keep pressed the cycle button ‘’C’’ during 3
seconds: lamp ‘’2’’ flashes during all the length
of the 5 or 10 minutes cycle, according to the
rinse’s duration fixed by default.
ACHIEVEMENTS
Any deficiency in the washing process is apparent
when dirty residuals are visible. An insufficient rinsing
might cause any halos: in this case, check that the
rinsing jets are clean and there is a sufficient pressure
in the water distribution network.
In the case that residuals are present, check that:
• the washing jets are clean
• there is detergent
• the pump suction filter is clean
• the positions of the objects in the rack are correct.
DISHES POSITIONING
It is suitable to place dishes, inside the plastic basket
with the concave side facing upwards. Place mixed
cutlery in a vertical position into the suitable container
minding not to cram them and with handgrips towards
the bottom (see drawing).
REGENERATING
(for machines with Water softener)
If the glass-washer is equipped with a Water softener
the
regeneration of resins
is automatic
according to
parameters fixed by the producer.
According to the water hardness, it is possibile to
modify the programming of the regeneration. See the
corresponding table in the installer section.
N.B. each 90 seconds of tank filling
duration, the machine stops for about
2 minutes to carry out the
regeneration.
SALT CONTROL
When it is necessary to add salt in the container, the
green lamp
"E"
is flashing.
Unscrew the plug of the salt container at the bottom of
the tank and put 1 kg coarse salt tablets in it. Clean the
gasket and screw the plug.
Attention!
The lack of salt in the container damages the machine
because of limestone, besides a defective washing of
glasses and dishes.
These damages are not covered by the warranty.
DRAIN PUMP INSTRUCTION
(only for machines with drain pump)
The drain pump starts up automatically just during
the washing cycle
to discharge the exceeding water
coming from the rinsing cycle.
At the end of the working day, in order to
completely discharge the tank,
it is necessary to
perform the following operations:
1. Open the door of the dishwasher
2. Remove the overflow pipe from the tank;
3 .Afterwards push button
“F” for 3 seconds.
Alternatively are flashing the control lamp “
E
” and the
cycle lamp (chosen before)
The discharge will stop automatically after 5 minutes.
The control lamps will stop flashing.
The drain can be stopped at any time by pressing
again button ‘’F’’ .
Please note: in case the door is open the control lamp
“E” will continue flashing.
Reinstall the flow over and shut the door.
