lamber 015-ek-plus, Инструкция по эксплуатации

Страница: 29 / 43

DETERGENT DISPENSER, RINSE-AID
DISPENSER AND LIMESCALE :
PROGRAMMING
For programming see section CONFIGURATION
USER TECHNICAL-PROGRAMMING The control
acts on the percentage values from 0% to 100%
with the logic time/pause according to the values
shown in the following table:
0% always OFF
10% 0,5s ON and 4,5s OFF
20% 1,0s ON and 4,0s OFF
30% 1,5s ON and 3,5s OFF
40% 2,0s ON and 3,0s OFF
50% 2,5s ON and 2,5s OFF
60% 3,0s ON and 2,0s OFF
70% 3,5s ON and 1,5s OFF
80% 4,0s ON and 1,0s OFF...
90% 4,5s ON and 0,5s OFF
100% always ON
Example :
Adjusting the rinse aid dispenser with 40% rinsing
time 20 s
The operating times will be:
2s ON + 3s OFF + 2s ON + 3s OFF + 2s ON + 3s
OFF + 2s ON + 3s OFF
For a fotal of 20 seconds onf rinsing.
Set the percentage based on the capacity of the
pump installed and rinsing time selected, taking
into account that the pump is running
simultaneously with the step of rinsing.
If there is the detergent pump installed by
Lamber, data are as follows:
Capacity: 1cc/SEC=3,6 Lit/H
Voltage: 230/50-60Hz
DETERGENT DISPENSER
INSTALLATION AND CONNECTION OF THE
DETERGENT DISPENSER
CAUTION : Observe the safety notes and
dosage data for the use of chemicals. During
the use of the chemical substance wear
protective clothing, gloves and glasses. Do not
mix different cleaning products.
If the machine is not fitted as standard, must be
accompanied by detergent dispensers oft he
suppliers of those products.
Entering DETERGENT WASHING LIQUID must
be carried out using the hole provided on the
front of the washing tank (see photo below)
The mean concentration of the liquid detergent
should be 2-4 g/liter. In any case it is however
necessary that the detergent manufacturer
regulates in an appropriate dosage depending on
the characteristics of the installation.
For the installation of the dispenser inside the
machine, you can use the free support next to the
rinse dispenser installed as standard on the
dishwasher (see next photo)
The suction tube of liquid detergent has to be
passed through the opening spot on the right side
of the machine (see next photo)
The choice of a suitable cleansing agent is an
essential condition if you want to obtain
extremely good washing results as regards
hygienic results. That’s why it’s important to
consider some points. First of all only highly
alkaline and chlorine-active antifoam products,
especially made for industrial dish-washing