lamber 015-ek-plus, Инструкция по эксплуатации

Страница: 14 / 43

14
machine «OFF»
Hood
closed
Remove the
overflow
Wait the End
of the drain
(with drain pump
press button)
keep
button
pressed
for 3 sec.
1
2
3
4
-
Self-washing cycle : with the machine ”ON” do
the following operations::
-1
Put the machine OFF by pressing the
push-button “A” ( led off)
-2 Remove the overflow of the tank and wait
until same is empty;
For machines equipped with drain pump, see the
instructions at the specific paragraph.
For machines without drain pump:
Visually check that the tank is empty,
-3
Close the hood of the dishwasher ;
-4 Hold the ” ” button for 3 seconds
.
ATTENTION: before your press the ”
”
, button,
make sure that the display shows the logo lamber
”
”.
In case it is off, turn the machine on by pressing the
switch “A” and then pressing it again to to turn off
again the push button “A”
The logo Lamber will reappear and will then be able to
start the function SELF-WASHING holding down the
select push button ” ” for 3 seconds
On the display you will see the words “SELF-
WASHING” with the time bar that indicates the
icrease for the duration of the cycle of 5 or 10
minutes depending on the time of rinse set by
default
If you want
to stop the cycle SELF-WASHING, it
is sufficient to press the switch “A”
DRAIN PUMP INSTRUCTIONS (optional)
(only for machines with drain pump)
The pump discharge function allows you to
automatically download the wash tank at the end
of the workday.
machine«OFF»
Hood
open
Remove the
overflow
1
2 3
keep
button
pressed
for 3 sec.
The operation of the discharge pump
is
automatic only during the cleaning cycle to
drain the excess water that enters during the
rinsing phase
At the end of the working day, to discharge
the tank completely,
you must perform the
following steps:
-1
Put the machine OFF by pressing the
switch “A” (the display shows LAMBER
logo);
-2
Open the hood of the dishwasher;
-3
Remove the OVERFLOW from the tank
4- Then press the “B” cycle-button for 3
seconds
Alternately flash the words “DRAIN” and
“REMOVE OVERFLOW”
(N.B. The word “REMOVE OVERFLOW” will
disappear only to the closing of the hood)
The discharge stops automatically after about 5
minutes.
The discharge can be interrupted at any time by
pressing the cycle-button
“B”
After drainig, the machine will turn off
completely (display OFF).
Replace the overflow into place and close the
hood.
DESCALING (optional)
(only for machine with drain pump and
dispenser )
The descaling function
is a cycle that leads
descaling liquid in the pipelines of rinsing, in the
washing tank and boiler allowing the removal of
limescale deposits from the water products.
The cycle lasts about 35 minutes.
For an average water limestone is recommended
cycle activation at least once a week.
The frequency may vary depending on type of
water.
machine «OFF»
Hood
closed
Remove the
overflow
keep
button
pressed
for 3 sec.
keep button
pressed for 3 sec
and w
.
ait the End
of the drain
1
2
3
4
To make the cycle do the following operations:
-1
Punt the machine OFF by pressing the
switch “A” (led off)
-2
Remove the OVERFLOW from the tank;