20
Folding arm awning manual, 4-2008
C) If the arms first touch the wall when retracting, and only then close,
they must be adjusted as follows (figure 4):
a) Extend the awning until the fabric is hanging tension free;
b) Make a pencil mark at a few mm from the outside of the arm support
shoulder joint;
c) Slightly loosen bolts no. 1 and no. 2;
d) Tap the arm support shoulder joint until it is at the pencil mark;
e) Retighten bolts no. 1 and no. 2;
f) Check whether the awning now closes correctly. If this is not the case,
repeat the actions.
If the arms first touches the arm support shoulder when retracting, and only
then close, carry out the same steps but in the opposite direction. Therefore,
move the arm support shoulder joint inwards.
PLEASE NOTE!!!
•
The arms must be adjusted symmetrically.
•
The fabric must always run from above.
•
The fabric blocks in the arm support shoulder must always be slid
sideways briefly, so that the fabric has sufficient room to move. When
everything is correctly positioned, the fabric blocks must be slid against
the fabric again.
Figure 4
www.thegaragedoorcentre.co.uk
0800 525 442
www.thegaragedoorcentre.co.uk
www.thegaragedoorcentre.co.uk
0800 525 442
www.thegaragedoorcentre.co.uk
