SDC-CF20G
Hardware Integration Guide
Embedded Wireless Solutions Support Center:
http://ews-support.lairdtech.com
www.lairdtech.com/bluetooth
14
© Copyright 2015 Laird. All Rights Reserved
Americas: +1-800-492-2320
Europe: +44-1628-858-940
Hong Kong: +852 2923 0600
compliance requirements required with this module installed, such as (but not limited to) digital device
emissions and PC peripheral requirements.
I
MPORTANT
!
In the event that the two conditions above
cannot be met
(for example certain device
configurations or co-location with another transmitter), then the IC authorization is no
longer considered valid and the IC ID
cannot
be used on the final product. In these
circumstances, the OEM integrator will be responsible for re-evaluating the end
product (including the transmitter) and obtaining a separate IC authorization.
When using Summit’s IC grant for the SDC-CF20G, the integrator must include specific information in the
user’s guide for the device into which the SDC-CF20G is integrated. The integrator must not provide
information to the end user regarding how to install or remove this RF module in the user’s manual of the
device into which the SDC-CF20G is integrated. . In addition to the required FCC statements outlined above,
the following IC statements must be added in their entirety and without modification into a prominent place
in the user’s guide for the device into which the SDC-CF20G is integrated:
To prevent radio interference to the licensed service, this device is intended to be operated indoors
and away from windows to provide maximum shielding. Equipment (or its transmit antenna) that is
installed outdoors is subject to licensing.
The integrator must list out information for each antenna used with the host device into which the SDC-
CF20G is integrated.
Labeling Requirements
The final end product must be labeled in a visible area with the following notice:
Contains IC ID: 6616A-SDCCF10G
European Union
User’s Guide Requirements
The integrator must include specific information in the user’s guide for the device into which the SDC-CF20G
is integrated. In addition to the required FCC and IC statements outlined above, the following R&TTE
statements must be added in their entirety and without modification into a prominent place in the user’s
guide for the device into which the SDC-CF20G is integrated:
This device complies with the essential requirements of the R&TTE Directive 1999/5/EC. The following
test methods have been applied in order to prove presumption of conformity with the essential
requirements of the R&TTE Directive 1999/5/EC:
EN60950-1:2001 A11:2004
Safety of Information Technology Equipment
EN 300 328 V1.7.1: (2006-10)
Electromagnetic compatibility and Radio spectrum Matters (ERM); Wideband Transmission systems;
Data transmission equipment operating in the 2,4 GHz ISM band and using spread spectrum
modulation techniques; Harmonized EN covering essential requirements under article 3.2 of the R&TTE
Directive
