laguna P12/5, Руководство пользователя

Страница: 20 / 67

(3) Changing Scoring Blade
1. Discount the saw from the power source.
2. Move the blade tilt to 0° (blade 90° to table), and raise
the scoring blade all the way up.
3. Move the sliding table all the way forward to expose the
internal blade guard that covers the blade and riving knife.
4. To fix the scoring by offered U Tool and using the arbor
wrench to remove the nut. (The arbor nut has right hand threads and loosens by turning counterclockwise.
(Fig. 45-1)
5. Measure the main blade, and use the shims to stack the scoring blade set so the thickness matches the
thickness of the main blade.
6. Install the blade set, re-install the arbor flange and the arbor nut, and tighten them against the blade set.
7. Move the orange blade guard back into its original position, next to the blades, and center the sliding table.
8. Align the scoring blade set to the main blade.
(4) Rip Cutting.
The panel saw has the capability of rip cutting full size panel
panels, the sliding table removes the burden of sliding a large
and heavy panel over a stationary table surface. (Fig. 46)
The saw also with the capability of rip cutting smaller boards
which is using the machine as a traditional table saw.
Smaller, lighter boards are easier to slide across the stationary
cast iron table surface to the right of the saw blade.
Rip Cutting With The Sliding Table
：
1. Install the crosscut fence in the center stud hole. (Fig. 48)
Note
：
Drop the crosscut fence into the center stud hole
and rotate it to the 90° stop.
Check to make sure the fence is at 90° and adjust it. (Fig. 48)
2. Slide the protection block against the blade teeth to
calibrate the scale, then tighten the lock knob, and make
sure the scale will not be accurate if the protection
block is cut.
3. Set a lip stop to the desired width-of-cut.
4. Position the blade guard to the correct height for your
workpiece.
5. Load the workpiece onto the table saw.
6. Take all the necessary safety precautions, then perform the
cutting operation.
17
rear 90
。
forward 90° stop
Vertical
All manuals and user guides at all-guides.com