(10) Sliding Table Parallel Adjustment
The table is calibrated at the factory and please adjust if it
changes during the transportation.
To adjust the sliding table parallel with the main blade
:
1. Disconnect the saw from the power source.
2. Move the blade tilt to 0° (blade 90° to table) and raise the
main blade and scoring blade set up.
3. Mark the center of the blade with a felt tip pen, this will
allow you to take your measurements from the exact
same place on the blade.
4. move the sliding table all the way to one end, and using
a precision ruler, measure the gap between the edge of
the table and you mark on the blade. (Fig. 67)
5. Move the other end of the sliding table in front of the blade
and measure the gap.
6. Open the cover plates under each end of table and
loosen the table mounting bolts. (Fig. 68)
7. Move the end of the sliding table that needs to be adjusted
in front of the blade.
8. Using the ruler, watch the gap measurement and have
your assistant slowly make the adjustment to the parallelism
adjustment bolts (Fig. 69) until the gap size is equal to the
other side. (Fig. 69-1)
9. Repeat steps 7-8 until the gap between your mark on the
blade and the edge of the sliding table is even at both ends.
10. Tighten the jam nuts on the parallel adjustment bolts to
secure them in place.
11. Tighten the table mounting bolts and replace the access plates.
(11) Squaring Crosscut Fence to Blade
1. Make sure the blade is parallel with the sliding table.
2. Prepare the scrap test piece by cutting it to 32" x 32" and
number all four sides of the test piece.
3. Using the crosscut fence, cut 1/2" off of each side of the
test piece.
4. Measure the test piece diagonally from corner to corner, at all four corners are same size.
Note
:
If both measurements are not within 1/16" then the crosscut fence needs to be adjusted.
5. Loosen the set screw and rotate the cairn to square the crosscut fence.
6. Tighten the set screw and repeat 3-6.
22
Fig. 69-1
Cover
Fig. 69
Vertical
All manuals and user guides at all-guides.com
Содержание P12/5
