laguna Dake 14CX, Инструкция по эксплуатации

Страница: 22 / 37

14CX 22 REV#072023
The blade makes a clicking noise
1. Bad weld. Dress the weld or change the blade.
Blade overheats
1. Dull blade. Change the blade or resharpen the blade.
2. Pitch is too small for the depth of cut. Change to a blade with the correct pitch.
3. Guides too tight. Adjust the guides.
4. Material too hard for the selected blade. Change the blade.
5. Blade too thick for the diameter of the wheels. Change the blade.
Machine vibrates
1. Machine not level on the floor. Re-level the machine ensuring that it has no movement.
2. Damaged drive belt. Replace the belt.
The machine will not stop.
This is a rare occurrence, as the machine is designed to be fail-safe. If it should occur, and you
cannot fix the fault, seek professional assistance. The machine must be disconnected from the power
and not run until the fault has been rectified.
1. Stop switch faulty. Replace the stop switch.
2. Internal breaker faulty. Replace the breaker.
Motor attempts to start but will not turn
1. With the power disconnected from the machine, open the doors, and try to turn the wheel by hand.
If the wheel is not turning, check the reason for the jamming. Typical reasons are guides too tight;
wood jammed in the wheel. Adjust guides or remove jammed wood. Brake engaged. Disengage
brake.
2. Capacitor faulty. Replace the capacitor.
3. Motor faulty. Replace the motor.