laguna Dake 14CX, Инструкция по эксплуатации

Страница: 16 / 37

14CX 16 REV#072023
General Instructions:
1. Adjust blade guide assembly so that the blade guides are just above the workpiece (about 3/16”)
allowing minimum exposure to the blade.
2. If using the fence, move it into position and lock it to the guide rail. If you are using the miter
gauge for a crosscut, the fence should be moved safely out of the way.
3. Turn the machine on and wait a few seconds for the machine to fully get up to speed.
4. Place the straightest edge of the workpiece against the fence and push the workpiece slowly into
the blade. Do not force the workpiece into the blade. Let the blade do the work.
NOTE: ( DO NOT over feed that bandsaw blade. This will reduce blade life and have a greater
chance of breaking the blade).
5. When cutting long stock, the operator should use roller stands, support tables, or an assistant to
help stabilize the workpiece.
6. When cutting at an angle with a tilted table, provide a guide against which the material being cut
can rest. Freehand cutting at an angle can result in injury, and maintaining an accurate cut is
difficult.
High to Low Setting & FPM setting:
First we’ll explain the procedure to change the 14CX from high gear to low gear or vice versa. The
same procedure applies both ways.
Disconnect the machine from the power source before making any adjustments.
1. Turn the machine off and unplug from the power source.
NOTE : (The motor MUST BE OFF before going to the next step)
2. Once the motor is completely off, open the bottom door. In the back of the machine use the
adjusting handle to unlock motor position. Push the motor adjustment lever down to lift the motor
and give the belt slack.
3. The belt can now be moved on the lower and upper pulleys. Belt on back pulleys for high speed
and front pulleys for low speed.
4. Make sure belt is fully on the pulley before loosening the adjustment handle and lowering the
motor back down by lifting the motor adjustment lever.
Blade Speed Ranges (FPM)
Rear Pulleys High Gear Range 160 – 4400 FPM
Front Pulleys Low Gear Range 60 – 1600 FPM
Below is the procedure to change the speed (FPM) of the bandsaw (
SAW ON, AND RUNNING
).
1. To change to the desired speed on the bandsaw, the bandsaw MUST be on and the blade
rotating.
2. The speed adjuster knob is located on the control panel on the left-hand side of saw. Above this
knob displays current blade speed.
3. Slowly rotate the handwheel CW to increase the blade speed, or CCW to decrease the blade
speed. USE CAUTION: Never start the 14CX bandsaw with any slack in the drive belt.
Doing so can cause machine damage as the belt is forced to pull through the slack.