28
Fitting the rotating center.
Ensure that the bore of the tail stock is clean. The
rotating center has a number 2 Morse Taper that fits into
the tail stock.
Push the center into the tail stock bore firmly, and ensure
that it is securely located. To remove the center, rotate
the adjusting handle until it is as far back as possible and
this will eject the center.
Fitting the drive center into the head stock.
Do not attempt to remove faceplate without removing set screws.
The set screws set on a flat part of the spindle. Forcing the
faceplate off while set screws are set or not completely removed
away from threading can damage the lathe spindle.
To remove the face plate from the head stock spindle, insert the
removal tool into the hole in the face plate large diameter. Lock the
spindle with the lathe spindle lock and unlock the face plate by rotating
it. Take care not to drop the faceplate onto the bed of the lathe.
Ensure that the bore of the head stock is clean. The drive center has a
number No. 2 Morse Taper that fits into the head stock
Push the center into the head stock bore firmly, and ensure that it is
securely located.
To remove the center, push the removal shaft into the back of the head
stock, and give it a sharp knock. This will remove the drive center.
Note.
Never leave the removal shaft in the head stock with the machine running.
Rotating center
Adjusting handle
Removal tool
Spindle lock Face plate hole
Lathe spindle lock
Содержание REVO 24-36
