Laguna Tools MPSP12-4-0135, Руководство пользователя

Страница: 22 / 58

(18) Lubrication
Lubrication the areas indicated below every 6-12
months, depending on frequency of use.
1. Blade angling trunnion.
2. Sliding table ways.
3. Scoring blade worm gear
4. Blade height linkage.
5. Blade height bearing
6. Blade tilt worm gear
7. Blade height slide
(19) Replace Belts
To change V-belt for the main motor
1. Disconnect the saw from the power source.
2. Move the blade tilt to 45° (blade 45° to table) and raise
the main blade and scoring blade set up.
3. Open the motor cabinet door.
4. Loosen the three M12 bolt (Fig. 19 A)
5. Slowly upper the motor and then tighten the bolt.
Pull off the old V-belt and replace them with new ones.
6. Ensure the motor pulley and arbor pulley are lined up.
7. Loosen the M12 bolt, and pivot the motor down.
8. Tighten the M12 bolt after adjusting suitable tension.
9. Close and secure the motor cabinet door.
To change flat belt for the scoring motor (option)
1. Disconnect the saw from the power source.
2. Move the blade tilt to 0° (blade 90° to table) and raise
the main blade and scoring blade set up.
3. Open the motor cabinet door.
4. Push the scoring blade motor and remove the flat belt.
5. Place the flat belt on the scoring blade arbor, lift the
scoring motor and slide the flat over the scoring
motor pulley. (Fig. 19 C)
6. Close and secure the motor cabinet door.
90° tilt stop
hex nut
Lubricate
90 stop
bolt
A
Flat belt as scoring arbor
without scoring motor)
Scoring
blade arbor
Flat belt
Scoring
motor
Fig. 19 A
Fig. 19 B
Fig. 19 C
23