Laguna Tools MPSP12-4-0135, Руководство пользователя

Страница: 15 / 58

(5) Fitting the extension table
The sliding table was installed on the machine and calibrated to the cast iron table in manufacture.
1. Before the tables are leveled, do not tighten the bolts in follow steps.
2. Attach the large extension table with three cap screws, lock washers and flat washers (Fig. 5A)
3. Check the surfaces 0 degree the table with a straightedge (Fig. 5B)
4. Make sure table is parallel with saw table. , then adjust the leveling screw of foot studs in order to make it
parallel with saw table.
(6) Fitting the round bar and scale
1. Remove the washer and nut from the round bar first and insert the screw rod of the round bar into
the cast iron table position. (Fig. 6A)
2. Thread and M12-1.75 hex nut onto each stud and tighten the nut against the round rail
3. Thread and M12-1.75 hex nut and a flat washer half way onto each studs (6B)
4. Insert the studs into the table Tighten with an M12 hex nut, lock washer and a flat washer on each stud.
(Fig. 6C) Before operation, the 0° mark on the rip fence scale must be aligned with the blade
the to ensure to be accurate.
Fig. 6A
Fig.6B
Upper lock
Lower adjust
Fig.
Fig.
6C
Fig. 5B
16