5. Slide the rip fence body onto the rail, then place the adjustable ring on the sliding table end of the rail and
secure the ring with the set screw (Fig. 6D)
6 . Thread the lock handles (Fig. 6E) into the rip fence body and loosely install the fine adjustment knob.
7. Place the end washer on the end of the rip fence rail and secure it with the M8-1.25 cap screw and lock washer.
8. Check the height of the rip fence rail by sliding the rip fence along the rail and comparing the gap between
the fence body and the table.
9. Adjust the height of the rip fence rail, then tighten all of the nuts against the table showed
10. Check if the bottom of the rip fence rests on the surface of the table. If the rip fence does not rest on the table,
then the fence is correctly adjusted, otherwise, loose the set screw and adjust the hex bolt
to raise the round bar, tighten the set screw to lock the right height.
(7) Moving & fixing the base unit
Place a level on the saw table and adjusting foot stands, so the saw table is level from left to right and from
front to back. Lock the foot studs in position by tightening their jam bolts against the machine body. (fig. 7)
(8) Installation Riving Knife and Semi guard
The riving knife attaches with fix block, hex nut and washer in the place (Fig. 8B) , top distance need at least
3mm-5mm between the riving knife and blade. The semi blade guard fit over the riving knife and is secured in place
with head cap screw. (Fig.8A)
Fig.6E
Fig.6D
Fig. 7
Fig. 8A
Fig. 8B
17
Содержание MPSP12-4-0135
