Laguna Tools MPL1301-0130, Руководство пользователя

Страница: 18 / 32

18
Fitting moulder blades.
Disconnect the power from the machine and never conduct any maintenance
or fitting of cutters with the power connected to the machine.
The moulder blades are fitted into the same slots in the cutter head as the planer
blades. When fitting moulder blades, do not fit the two outside gibs. Only use the
central gib.
1. Fit the setting jig.
2. After cleaning the slot
blade and gib, fit the gib
and moulder blade into the
cutter head slot.
3. Loosely adjust the gib
screws so that there is
very little clearance
between the gib and the
blade but ensure that the
blade is not clamped.
4. Using the brass-tipped
rod, hold the blade firmly
down onto the bottom of
the cutter head slot while the edge of the blade is just touching the setting jig and
tighten the gib jacking screws.
5. Repeat for the other blades.
6. Adjust the red chip breaker so that it is fully clear of the cutters. Ensure that the
screws are tight.
7. Rotate the cutter head by hand to ensure that it rotates freely.
8. Remove the setting jig and refit the top cover and dust chute.
Setting the guides.
Disconnect the power from the
machine. Never conduct any
maintenance or fitting of cutters
with the power connected to the
machine.
The guides can be adjusted to any
position on the table. They must be
set in relation to the moulder blades
as follows.
1. Place the wood to be moulded on
the table against one of the guides.
2. Raise the table so that the
moulder blade almost touches the
job.
Moulder blade Setting jig
Guides