Laguna Tools MPL1301-0130, Руководство пользователя

Страница: 10 / 32

10
The planer/moulder major parts are discussed in this manual. If you are not
familiar with the planer/moulder, take the time to read this section and become
familiar with the machine.
1. Body.
The body is made from pressed steel and is designed to give the machine support
and rigidity.
2. Lifting rods.
The lifting rods are extendable from the machine. Lifting strops can be attached to
the rods when lifting or moving the machine.
3. Support rollers.
The support rollers support the work piece and effectively extend the table area.
4. Start/stop switch.
5. Power cable.
A power cable is supplied with the machine. The plug may not suit your electrical
installation and may have to be replaced.
6. Table.
The table is made from cast iron and supports the work while it is being machined.
The table has a fine ground finish.
7. Guides.
Adjustable guides are provided to adjust the position of the work when using the
machine moulder function.
8. Dust chute.
A 4-inch diameter dust chute is provided. The dust chute must be connected to a
dust collector with a minimum capacity of 1000 c.f/m. The machine produces a lot of
sawdust and wood chippings; the stronger the dust collector the better.
9. Table adjusting handle.
The table adjusting handle raises and lowers the table.
10. Motor.
The motor provides the power to the cutter head.
11. Cutter head.
The cutter head takes three planer knives or three moulder knives.
12. Tool tray.
The tool tray is located on the top of the machine for ease of access. It stores all the
tools and setting jigs that are supplied with the machine.
Where to locate your machine.
Before you remove your machine from the pallet, select the area where you will use
your machine. There are no hard-and-fast rules for its location, but below are a few
guidelines.
1. There should be an area at the front and back of the machine suitable for the
length of wood that you will be machining.
2. Adequate lighting. The better the lighting, the more accurate and safely you will
be able to work.
3. Solid floor. You should select a solid, flat floor, preferably concrete or something
similar.