Laguna Tools MPL1301-0130, Руководство пользователя

Страница: 24 / 32

24
2. Loosen the motor clamping nuts as detailed earlier in the manual.
3. Remove the drive belts.
4 . Fit the new belts.
5 . Re-tension the belts. There should be a 3/16" deflection when the belt is pressed
with moderate finger pressure. Tighten the motor clamping nuts.
6 . The drive belts should be checked after running the machine for approximately 10
hours. The belts bed into the pulleys and will slacken off slightly. If they are not
adjusted, slippage may accrue, and this will cause early belt failure. There should be
a 3/16" deflection when the belt is pressed with moderate finger pressure.
7. Refit the side cover.
Lubricating the machine.
Note.
All the bearings are sealed for life and do not require lubrication. If a bearing
is noisy, do not try to re-lubricate but replace it.
Note. It is recommended that you use a Teflon-based lubricant, as it tends to dry
and therefore will attract less sawdust and dirt.
Lubricate the drive chains and cogs.
Troubleshooting and fault finding.
Problem Cause
Corrective action
Motor will not start or
fuses or circuit breakers
blow. 1. Emergency button
depressed. 1. Reset the emergency
button.
2. Short circuit 2. Repair or replace short
circuit item.
3. Start capacitor faulty. 3. Fit new capacitor.
4. Motor thermal
protection circuit breaker
faulty, or motor is at fault. 4. Replace thermal
protection circuit beaker
in motor or replace
motor.
5. Open circuit in motor
or loose connections. 5. Replace or repair
motor or loose
connection.
Fuses or circuit breakers
blow. 1. Motor drawing
excessive current. 1. Repair or replace
motor.
2. Cutter head or motor
jammed. 2. Remove jam.
3. Short circuit. 3. Repair or replace short
circuit item.
Motor will not develop full
power or motor speed
slows with load, over
heats or stalls. 1. Motor run capacitor
faulty. 1. Replace the capacitor.
2. Machine overloaded. 2. Take smaller cuts.
3. Motor overheating. 3. Clean motor, taking