Laguna Tools METAL PRO Series, Руководство пользователя

Страница: 35 / 66

35
Pressure roller adjustment.
Pressure roller adjusting studs & nuts
There are four pressure rollers: two on the infeed side and two on the
outfeed side of the contact roll. The pressure rollers come factory set but
may need to be adjusted during the life of the machine or certain
applications.
Adjust the rollers as follows.
1. Place a panel on the bed of the sander so that it is under both the infeed
and outfeed rollers.
2. Set the bed of the sander vertically so that one of the pressure rollers just
touches the panel.
3. Loosen the lock nuts and adjust the pressure rollers so that they are both
just touching the panel. This must be completed at the extremities of the
rollers to ensure that they are parallel.
4. With the rollers parallel, adjust the rollers to the required setting and lock
the lock nuts.
Note. When adjusting the height of the pressure rollers, after ensuring that
they are parallel, adjust each screw the same amount or the rollers will not
be parallel.
Note. Adjusting the pressure rollers must be done with the sanding belt
stationary.
Note. The amount of pressure that you set the pressure rollers to exert on
the job will vary depending on such variables as the depth of cut, hardness