Laguna Tools METAL PRO Series, Руководство пользователя

Страница: 17 / 66

17
Connecting air supply.
Air line connection
Air pressure
regulator
Label
The input air regulator regulates the air pressure that is supplied to the
machine. The machine is supplied with an air connector, to connect the
air supply. An air supply that can deliver a constant minimum pressure
of 6 bar (87 psi.) is required. The machine is supplied with an input air
regulator that you will need to adjust to 6 bar (87 psi.) once you have
connected your air supply to the machine.
Note. No air pipe is supplied, as the length will depend on your
installation.
To adjust the air pressure, pull the cap up and rotate until the gauge
reads the correct pressure. Once the pressure is adjusted, push the cap
in.
Note. An air supply of 6 bar (87 psi.) minimum is required for the machine.
It is strongly recommended that 7 bar (102 psi.) be supplied to the
machine and that the regulator then be set to 6 bar (87 psi.). This will
ensure that the machine always has the minimum required air pressure.
The input regulator has a moisture trap that must be emptied each day.
Note. It is important that the air that is supplied to the machine be clean
and dry. The machine will not perform consistently if the air is dirty, as
any dirt will block the valves. Wet or damp air will damage your machine
and cause inconsistent performance.
Note. The pneumatic system does not need any type of lubricant. Some
types of lubricant can damage the machine and compromise the
machine’s functions.
Note. During maintenance, always disconnect the air supply.