13
Where to locate your machine
Before you unpack your machine, select the area where you will use your machine. There are
no hard and fast rules for its location, but below are a few guidelines.
1.
There should be an area around the machine suitable for the length of material that you will
be machining.
2.
Adequate lighting. The better the lighting, the more
accurately
and safely
you will be able to work.
3.
Solid floor. You should select a solid flat floor, preferably concrete or
something similar.
4.
Close to power source and dust collection.
Unpacking your machine
To unpack your machine, you will need tin snips, a knife and a wrench.
1.
Using the tin snips, cut the banding that is securing the machine to the
Pallet [if fitted].
WARNING: EXTREME CAUTION MUST BE USED BECAUSE
THE BANDING WILL SPRING AND COULD CAUSE INJURY.
2.
Remove the box from the CNC machine if fitted and any other packaging material. The
parts ordered with the machine will be packed on or inside the machine.
Note.
The machine is heavy, and if you have any doubt about the
described procedure, seek professional assistance. Do not attempt any procedure that you
feel is unsafe, or that you do not have the physical capability of achieving.
3.
Use a fork lift with sufficient lifting capacity and forks that are long enough to extend the
complete width of the machine.
4.
Remove the securing bolts that attach the machine to the pallet [if fitted].
5.
Approaching the machine from the side, lift the machine on the frame taking care that there
are no cables or pipes in the area of the forks.
6.
Move the machine to the required position and lower gently to the floor.
Содержание MCNC Swift 60 X 120-0233
