To start the generator:
•
Make sure all the 110v systems have been switched off prior to starting
the generator.
•
Make sure the shore power/generator breakers have been switched over
to generator mode.
•
Press the top of the “GenSet” switch and hold.
•
After a slight delay the light on the switch will flash and go green, you will
hear the generator start.
•
Allow the generator to warm up for 5 minutes and then gradually load up
the system, adding one load every 5 minutes.
Stopping the generator
•
Press the bottom of the switch and release. The generator will close
down.
You must not run the generator when underway.
Generator start and stop button. Press the top
and hold until generator starts. Press bottom
and hold for generator to stop.
Shore
power/generator
breakers.
Make sure generator mode is selected
prior to starting the generator.
