15
ENGLISH
5.3.1 Disposable
Canister System Quick reference
The assembly of the tubing is illustrated on the
right side of the LSU.
1. Connect the blue Vacuum Connector on the
Vacuum Tubing to the blue Vacuum Inlet.
2. Connect the two yellow connectors to the
yellow T-bar on the Abbott canister.
3. Connect the white Patient Tubing to the
white Patient inlet.
5.4 After Use
- When suction is complete, set Operating
Knob to ”0” and inspect all parts for damage
or excessive wear. Replace parts if necessary.
- Clean the LSU according to section 6.3.
- Perform the Device Test according
to section 7.
- Place the LSU on charge (see section 6.5).
6. Maintenance
6.1 General
- Make sure the maintenance instructions
under section 4.4 and 5.4 are followed.
- If the device is not in frequent use
(i.e. less than once a month), the Device Test
(see section 7) should be performed both on
a monthly basis and after each use.
6.2 Battery
- To maintain satisfactory operation of the
battery, it is recommended to place the LSU
on continuous charge when not in use.
- Replace the battery when it does not pass
the Battery Quality Check (see section 6.6
for details), or after 3 years.
- Do not store the LSU with an empty battery.
6.3 Clean the Cabinet
Warning: Disconnect the LSU from external power
prior to cleaning.
Use a minimum of liquid to prevent any electrical
shock hazard. Do not immerse the LSU or allow it
to stand in water or other liquids. This can damage
the device, and cause electrical shock resulting in
injury to persons.
- Use a cloth or sponge that is dampened with
a mild detergent (hand dishwashing liquid or
similar) to clean the external surfaces of the
LSU. Use a detergent that is compatible with
the materials listed under section 11.7, and
follow the detergent manufacturer´s
instructions.
- Use a cloth or sponge dampened with water
and wipe the surfaces again.
- Dry the surfaces using a clean cloth or
a paper towel.
