LaCie Dupli 125, Руководство пользователя

Страница: 15 / 50

4. Copy mode
The Dupli 125’s Copy mode enables you to copy CD media, verify the results, set the write
speed and configure the session parameter to meet your needs. This chapter describes how
to do all of these.
Any changes to the copy mode, write speed or session parameters
(described below) are erased from the Dupli 125’s memory once the unit is
turned off. When you turn the Dupli 125 on again, any changes to the default
settings will have been erased and the unit will have returned to its default
Copy settings.
4.1 Introduction to Copy mode
The COPY mode at maximum speed and close session is the Dupli 125’s default duplication
operation. To set another mode or change the duplication speed, you have to access the
SETUP (MODE CHANGE) menu and change the settings.
4.1.1 Various copy and verification functions
Function LCD message Description
Copy >> COPY ? Duplication from a master disc to blank discs.
Verify >> VERIFY ? Compares copied data with master data bit per
bit. The CD-DA, CD-ROM XA Form 2 and CD-
EXTRA formats cannot be verified.
Copy and verify >> COPY + V ? A two-phase operation. In the first phase, a
master CD is duplicated onto blank CDs. The
second phase compares the copied data bit by bit
with the master data. The CD-DA, CD-ROM XA
Form 2 and CD-EXTRA formats cannot be
verified.
Read check >> RD CHECK ? Checks whether copied discs can be properly
read or not.
Copy and read >> COPY + R ? A two-phase operation. In the first phase, a
master CD is duplicated onto blank CDs. The
second phase checks whether the copied discs
can be read properly or not.
When duplicating a master CD, do not mix CD-R and CD-RW media in the
target drives. When duplicating a master disc, use either only all CD-R or all
CD-RW media in the target drives. Likewise, use only CD-R/RW media that
support the same maximum write speed (10x, 12x, 16x, etc.). Otherwise, a
duplication error will occur, and your CD-R media may be unusable.
!
i