INSTALLER’S MANUAL
Comissioning (fine tuning) gas burner :
After connection or changing gas type, it is imperative to adjust for a fine tuning.
►
Ignite all the burners on the hob.
►
After a couple of minutes, reduce to lowest setting.
►
Remove control knob by pulling it off (see
G
/figure
5
).
►
Using a flathead screwdriver adjust the simmer flame accordingly (see
G
, figure
5
).
Note: The flame is reduced to ¼ when you turn maximum to minimum. Looking for a crisp
blue flame without any yellow which does not go out when turned from maximum to mini
-
mum.
Setting the safety thermocouple (Hob) :
If the burner goes out, having kept the control knob pushed in for roughly twenty seconds, check
that :
-
The magnetic head grips the valve moderately, finger right.
-
The flame touches the point of thermocouple
(see
H
, figure
6
).
- The thermocouples and magnetic heads are absolutely clean.
Remove control knob by pulling it off (see
H
figure
6
).
Using a flathead screwdriver adjust the simmer flame
OVEN :
►
Open oven door and remove oven base plate by pressing down and backwards and then lifting
out (see
I
, figure
7
).
►
Remove drawer.
►
Through the drawer aperture, loosen 7mm nut (see
K
, figure.
9
)
.
►
Remove the 8mm nut and grub screw and washer within it at the front of the burner (see
J
, figure
8
).
CHANGING GAS TYPE
G
5
6
H
7
I
J
8
Sully - Ft 124a - GB - Rév 06 - Modifié le : 07/10/2013 14/42
