SECTION 6. ELECTRICAL INSTALLATION
ELECTRICAL HAZARD
DISCONNECT ELECTRICAL SUPPLY
BEFORE PROCEEDING FURTHER
The extractor is a stationary appliance designed to be connected by fixed wiring to the electrical supply. A competent
electrical technician must perform the electrical installation.
The hood must be fed from a 230Vac single phase electrical supply using a switched spur fitted with a
3A fuse for single
blower
models or a
5A fuse for double blower
models . The spur should be located adjacent to the hood/cooker so that the
supply can be disconnected from the hood using the switch. The means of disconnection from the supply must have a
minimum contact separation of 3mm in all poles. Alternatively, a means of disconnection in the fixed wiring according to the
relevant wiring rules must be fitted.
A supply cord for connecting the spur to the extractor is included.
The mains supply is connected to the free end of this cord as follows:
INCOMING SUPPLY CORD CONNECTIONS
Core
Core Colour
Live
Brown
Neutral
Blue
Protective Earth
Green/Yellow
SECTION 7. WARNING
Proper care must be taken to ensure that the negative pressures caused by high performance extraction systems do not
adversely affect the safe operation of certain types of fuel-burning appliances (gas, oil, or solid fuel), including those installed
in the kitchen and possibly also those installed in other parts of the house.
Where such fuel-burning appliances are installed, adequate ventilation MUST be provided in the room of installation, located,
and sized such that the negative pressure in the room created by the extractor does not exceed 4Pa.
In case of doubt, do not operate the extractor and fuel-burning appliance(s) simultaneously and consult an appropriate (for
the fuel type) expert for advice.
Should you require any further technical information please do not hesitate to call Fourneaux de France Ltd on:
01202 733011
SECTION 8. OPERATING INSTRUCTIONS
A.
Light switch on/off
B.
Motor switch on/off (1st level)
C.
Second speed motor switch
D.
Third speed motor switch
E.
Fourth speed motor switch
F.
10 minute run on timer switch
Fig 10 Extractor Controls
Grease Filter alarm
