Labrie Pendpac WITTKE RETRO FL, Руководство по обслуживанию

Страница: 39 / 130

Safety
29
2. Set the chassis parking brake.
3. Check for overhead clearance.
4. Chock the front and rear tires.
5. Remove left and right body latch pins.
6. Unlatch the body safety prop spring pin latch.
7. Raise the body far enough to allow the body safety prop to hang vertically.
N
OTE
:
Do not raise the body higher than is required to engage the body safety prop. If the unlatched
prop does not swing into a vertical plane when the body is raised, the prop has been damaged
and must be repaired prior to use.
8. Lower the body until the body safety prop landing pads fit into the retainer cutouts and seat
securely on to the chassis frame.
9. Complete the lockout/tagout procedure (see
Lockout/Tagout Procedure
on page 37).
Tailgate Props
The tailgate props, one each side, when engaged, ensure that the tailgate cannot close.
Setting the Tailgate Props
N
OTE
:
Never walk or work under the tailgate without first positioning the tailgate props!
To set the tailgate props:
1.
Ensure that there is adequate clearance behind the vehicle to allow for tailgate.
2.
Remove both tailgate lock blocks.
3.
Open the tailgate so that the bottom portion is approximated 36” away from the body.
4.
Unlatch each prop from its stored position and allow it to swing out 90 degrees, or perpendicular
to the tailgate frame.
5.
Lock the props in place by releasing the spring latch rods so they engage the holes provided.